This issue has now been fixed.Ĭorner wrapped gusset (63): Previously, the option to specify gusset welding to the main or secondary part on the Gusset tab was not working correctly. This issue has now been fixed.Ĭorner wrapped gusset (63): Previously, the brace connection filler plate was not included in bolted parts. The following detailing system components cannot be used with the Metsec mezzanine range anymore as using them would cause incorrect CAM data: Metsec Apex tie bay (12), Metsec Std anti-sag bay (23), Metsec Non-std anti-sag (25), and Metsec Apex ties (30).īase plate (1004): Previously, deleting bolts did not work correctly when bolts were placed below the main part. Multiple stiffeners (1064): Previously, the component did not work correctly for main parts created as composites of welded parts. Tube gusset (20): Previously, the end plates were not created correctly when the secondary parts had different inclination. Ring plate: Previously, when using two half ring plates, only one weld was created between them. Stiffened end plate (27), Partial stiffened end plate (65): It is now possible to specify the front plate horizontal offset.ĬMF Standard horizontal cladding support (31): You can now select on which side the sheeting face is. Simple clip angle (31), Two sided clip angle (33): Previously, when the main part was sloped, the cope cuts were not created correctly. Railings (S77): Previously, an incorrect fitting was created between the first and last part of the bottom rail and the first and last stanchion. Railings (S77): Previously, the top rail was created with an incorrect profile in some situations. Z pan (S74): Previously, the gage material UDA was incorrectly set for bent plate brackets. Tapered I-beam (81): Previously, UDAs were not written for some shapes of the tapered beam. Sloping slab drainage: The inclination calculation for rectangular drainage holes has been improved. The possible value is true or false.įormwork placing tools - Walls: A new option to control the stack height has been added. Formwork placing tools: A new button to reload the available tool configurations has been added.įormwork placing tools - Walls: New options to define custom part at the start and at the end of platforms can be set in the Platforms.csv file.įormwork placing tools - Walls: A new option AllignClampsToWall can be set in the Walers.csv file.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |